Extensive testing of productions sample:
Electrical, Full Environmental and Mechanical
Vecta Labs has witnessed a very significant failure rate in new tower top RF components used in cellular systems.
With over four years of testing involving greater than 300 samples from many suppliers, the failures have been categorised into major and minor, electrical and mechanical, and into groupings of failure modes.
Independently measured hard reliability and performance information of this type is essential to manufacturers and network operators, to enable proactive management of these tower top quality issues.
Vecta Labs enables the problems to be identified, accurately measured and rectified before installation. Without this, the solution may demand expensive and logistically difficult rectification on the tower.
Component Testing
Extensive testing of every sample:
Electrical, Full Environmental and Mechanical
Vecta has witnessed a very significant failure rate in new tower top RF components used in cellular systems. With over four years of testing involving greater than 300 samples from many suppliers, the failures have been categorised into major and minor, electrical and mechanical, and into groupings of failure modes.
Independently measured hard reliability and performance information of this type is essential to manufacturers and network operators, to enable proactive management of these tower top quality issues.
Passive Antenna, DAS, IBC Testing
Vecta Labs enables manufacturers and network operators to pre-qualify base station antennas and in building coverage antennas before installation, to ensure the very best performance for subscribers.
Otherwise performance is left to chance.
Vecta Labs uses a far-field antenna range together with a dedicated specialist laboratory to qualify the performance of large and small passive antennas used in cellular systems.
Not all antennas are the same and these differences in performance have a large impact on network quality.
