Vecta Sure Qualification Testing

Extensive testing of productions sample:

Electrical, Full Environmental and Mechanical

Vecta Range

Vecta Labs has witnessed a very significant failure rate in new tower top RF components used in cellular systems.

With over four years of testing involving greater than 300 samples from many suppliers, the failures have been categorised into major and minor, electrical and mechanical, and into groupings of failure modes.

Independently measured hard reliability and performance information of this type is essential to manufacturers and network operators, to enable proactive management of these tower top quality issues.

Vecta Labs enables the problems to be identified, accurately measured and rectified before installation. Without this, the solution may demand expensive and logistically difficult rectification on the tower.

Component Testing

Extensive testing of every sample:

Electrical, Full Environmental and Mechanical

Vecta has witnessed a very significant failure rate in new tower top RF components used in cellular systems.  With over four years of testing involving greater than 300 samples from many suppliers, the failures have been categorised into major and minor, electrical and mechanical, and into groupings of failure modes.

Independently measured hard reliability and performance information of this type is essential to manufacturers and network operators, to enable proactive management of these tower top quality issues.

Component Testing

Passive Antenna, DAS, IBC Testing

Vecta Labs enables manufacturers and network operators to pre-qualify base station antennas and in building coverage antennas before installation, to ensure the very best performance for subscribers.

Otherwise performance is left to chance.​

Vecta Labs uses a far-field antenna range together with a dedicated specialist laboratory to qualify the performance of large and small passive antennas used in cellular systems.

Not all antennas are the same and these differences in performance have a large impact on network quality.

External Passive Intermodulation Measurements

Vecta has the capability to measure the passive intermodulation (PIM) generated by objects exposed to RF radiation.  Often described as “external PIM measurements”, Vecta can carry out testing in the 600 – 4000 MHz range according to IEC standard 62037-8.  This may be of interest to manufacturers or end users of any material or object, for example radomes, shielding materials, connectors, cables, mounting hardware etc.

Vecta Labs Science & Technology Services

Vecta Sure Qualification Testing
Vecta Sure Qualification Testing
Vecta Sure Pre-Commission Testing
Vecta Sure Pre-Commission Testing
Vecta Academy
Vecta Academy
Cell Site Services
Cell Site Services
Cell Site Works
Cell Site Works

Vecta Labs Science & Technology Services

Vecta Sure Qualification Testing
Vecta Sure Qualification Testing
Vecta Sure Pre-Commission Testing
Vecta Sure Pre-Commission Testing
Vecta Academy
Vecta Academy
Cell Site Services
Cell Site Services
Cell Site Works
Cell Site Works